I need to make some refinements to the 3D printed adapter, but the initial prototype works well. https://mastodon.emory.coffee/media/JSLhkTDzqqFjupP6n04 https://mastodon.emory.coffee/media/_hPkDjlr__ItYUpKhrk
The next step is finding a new lens. The 85mm that came with it doesn’t have PC sync and my 150mm is too long.
I think I've settled on the design for the real adapter. The goal is for it to be easy to make, ideally in a single CNC run on the back side.
The 65 mm lens arrived so I was able to properly test the adapter. It's safe to say I do not have the sensor registered to the ground glass correctly 🙁
@emorydunn Oh, that’s a bummer. Do you have an idea of how far off you are?
@pjonori Looks like it's a whole 3.5 mm! It looks like both my measurements and assumption of how deep the sensor is were wrong.
@emorydunn Yikes! That's a decent amount in regards to optical engineering.
@pjonori No criticism taken. I'm gaining a new appreciation for camera construction. I have CAD and a 3D printer, I can't imagine doing all of this by hand.
@emorydunn I'm not going to lie, I'm following your project with a lot of fascination and appreciation.
I've always wanted to build a camera. Then I start thinking about how much goes into it and I need to breath into a paper bag.
@pjonori I'm glad other people can get something out of my pet project.
I'm constantly amazed at the DIY cameras people build. Though it's rare to see the process behind it.
@emorydunn Seems like a major challenge. My statement was in no way intended to criticize - more to call out the frustratingly exacting precision needed for construction.